- Home /
- Marine Electronics /
- Autopilots /
- Coursemaster Autopilots /
- Coursemaster CM80i Autopilots
Shop Now
- Anchoring & Mooring
- Boat Maintenance
- Deck Hardware
- Electrical
- Fishing Equipment
-
General Equipment
- Cabin Hardware
- Coverings
- Galley
- Handles, Handrails & Fittings
- Hatch Hardware
- Marine Engineering
- Navigation
- Seat & Table Assemblies
- Ski Accessories
- Trailer Components
- Tube Clips
- Ventilators
- Windscreen Wipers & Accessories
- Marine Clothing
- Marine Electronics
-
Plumbing
- Fresh Water Systems
- Hose & Hose Accessories
- Pumps
- Toilet Systems
- Rigging Products
- Safety Equipment
-
Sailing Hardware
-
Blocks
- Harken
-
Ronstan
- Deck Organisers
- Lightweight Blocks
- Orbit Series Block Accessories
- Ronstan General Purpose Blocks
- Ronstan Wire Rope Blocks
- Series 100 Core Blocks
- Series 15 Ball Bearing
- Series 20 Ball Bearing
- Series 30 Orbit Blocks
- Series 40 All Purpose Blocks
- Series 40 Orbit BB Blocks
- Series 40 Orbit Blocks
- Series 40 Orbit Ratchet Blocks
- Series 50 All Purpose Blocks
- Series 55 Orbit Blocks
- Series 55 Orbit Ratchet Block
- Series 60 Core Blocks
- Series 70 Orbit Blocks
- Series 75 Core Blocks
- Sheave Boxes/Exit Blocks
- Snatch Blocks
- Utility Blocks
- Stainless Steel Hardware Blocks
- Boom Fittings
- Mast Tangs & Hounds
- Rope Stoppers
- Rudder & Tiller Fittings
- Saddles, Fairleads & Bushes
- Sail Furlers and Feeders
- Sail Slides, Hanks & Shackles
- Sheet Winches & Access.
- Shock Cord Ends & Tiedowns
- Spinnaker Pole Ends & Fittings
- Spreader/Mast Fittings
- Stay Adjusters
- Tiller Extensions and Uni Joints
- Trapeze Hardware
- Traveller Tracks
- Wind Direction Indicators
-
Blocks
- Sta-Lok Swageless Rigging Components
Coursemaster CM80i Autopilots
Description
Coursemaster's CM80i breaks new ground in intelligent autopilots. The new features of this system make it both easier to install and very easy to use. The intelligence built into the system means that there is no need for a rudder transducer and the system adjusts itself to suit the boat speed and sea state. The CM80i's compact design fits easily into almost any small boat dash and closely matches engine instruments. Installation can be completed easily and once installed, requires a simple, once only set up procedure which takes less than a minute. The CM80i's main components are the control head which can be flush or bracket mounted, the junction box, a rate gyro compass and a hydraulic pump. The CM80I interfaces with GPS, has a heading output for radar and an optional rate gyro. It comes with fitting kit for 3/8 hydraulics - There is an optional hydraulic fitting kit available for1/2" systems.
"